[네트워크] 알테온(Alteon) L4 기본 컨피그 설정 정리
* 장비 콘솔 접속: 9600 buad rate로 접속합니다.
* 디폴트 패스워드 (Default Password : admin)
Enter password: admin
System Information at 2!
Time zone: No timezone configured (GMT offset -8:00)
Memory profile is Default
Alteon Application Switch VA
Switch is up 0 days, 0 hours, 0 minutes and 12 seconds.
Last boot: 2:31
Last apply: 7:42:2
Last save: 0:2
Management MAC Address :
Port 1 MAC Address :
Port 2 MAC Address :
License Key :
Management IP Address :
Software Version 2~ (FLASH image1), active configuration.
HA State: NONE
* 리부팅하기
>> Main# /b/reset
------------------------------------------------------------------
[Boot Options Menu]
image - Select software image to use on next boot
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP/SCP
reset - Reset switch
shutdown - Shutdown switch
cur - Display current boot options
* 장비 셧다운하기
>> Main# /b/shutdown
------------------------------------------------------------------
[Boot Options Menu]
image - Select software image to use on next boot
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP/SCP
reset - Reset switch
shutdown - Shutdown switch
cur - Display current boot options
* 장비 초기화하기 (Factory default)
>> Main# /b/conf
Currently set to use active configuration block on next boot.
Specify new block to use ["active"/"backup"/"factory"]: factory
Next boot will use factory default configuration block instead of active.
Confirm : Do you want to keep management port connectivity? [y/n]: n
Confirm : Do you want to keep SSH keys? [y/n]: n
Deleting SSH keys from FLASH
SSH keys deleted
>> Boot Options# reset
Reset will use software "image2" and the factory default config block.
>> Note that this will RESTART the Spanning Tree,
>> which will likely cause an interruption in network service.
Confirm reset [y/n]:y
* MGMT 설정및 SSH key 값 초기화 여부확인 후 reset 명령어로 진행합니다.
* 패스워드 변경하기
>> Main# /cfg/sys/access/user
------------------------------------------------------------
[User Access Control Menu]
uid - User ID Menu
usrpw - Set user password (user)
sopw - Set SLB operator password (slboper)
l4opw - Set L4 operator password (l4oper)
opw - Set operator password (oper)
sapw - Set Slb administrator password (slbadmin)
l4apw - Set L4 administrator password (l4admin)
admpw - Set administrator password (admin)
cur - Display current user status
* >> User Access Control# admpw
Changing ADMINISTRATOR password; validation required:
Enter current admin password: ( 현재 password )
Enter new administrator password: ( 변경 password )
Re-enter new administrator password: ( 변경 password )
댓글